[lime-dev] lime-config error Hex (3zl Trizonelabs)

3zl Trizonelabs trizonelabs at gmail.com
Sat Aug 15 20:37:00 UTC 2015


lime

#    option bmx6_over_batman false
    # Disables Bmx6 meshing on top of batman
    #    option main_ipv4_address '192.0.2.0/24'
    # Parametrizable with %Mn, %Nn
    #    option main_ipv6_address '2001:db8::%M5:%M6/64'
    # Parametrizable with %Mn, %Nn
    #    list protocols adhoc
    # List of protocols configured by LiMe
    #    list protocols lan
    #    list protocols anygw
    #    list protocols batadv:%N1
    # Parametrizable with %Nn
    #    list protocols bmx6:13
    #    list resolvers 8.8.8.8
    # DNS servers node will use
    #    list resolvers 2001:4860:4860::8844


    ### WiFi general options

    #config lime wifi
    #    option channel_2ghz '11'
    #    option channel_5ghz '48'
    #    list modes 'ap'
    #    list modes 'adhoc'
    #    option ap_ssid 'LiMe'
    #    option adhoc_ssid 'libre-mesh'
    # Parametrizable with %M, %H
    #    option adhoc_bssid 'ca:fe:00:c0:ff:ee'
    #    option adhoc_mcast_rate_2ghz '24000'
    #    option adhoc_mcast_rate_5ghz '6000'
    #    option mesh_mesh_fwding '0'
    #    option mesh_mesh_id 'LiMe'


    ### WiFi interface specific options ( override general option )

    #config wifi radio11
    #    list modes 'adhoc'
    #    option channel_2ghz '1'
    #    option channel_5ghz '48'
    #    option adhoc_mcast_rate '6000'
    #    option adhoc_ssid 'libre-mesh'
    #    option adhoc_bssid 'ca:fe:00:c0:ff:ee'

    #config wifi radio12
    #    list modes 'manual'
    # If you use manual protocol you must not specify other protocol, or
your
    configuration will be broken!


    ### Network interface specific options ( override general option )
    ### Available protocols: bmx6, batadv, wan, lan, manual
    ### proto:vlan_number works too ( something like bmx6:13 is supported )
    ### If you use manual do not specify other protocols, may result in an
    unpredictable behavior/configuration (likely you loose connection to the
    node)

    #config net port5
    #    option linux_name 'eth1.5'
    #    list protocols 'manual'


    ### Ground routing specific sections
    ### One section for each ground routing link

    #config hwd_gr link1
    #    option net_dev 'eth0'
 #
    Plain ethernet device on top of which 802.1q vlan will be constructed
    #    option vlan '5'
 #
    Vlan id to use for this ground routing link, use little one because
cheap
    switch doesn't supports big ids, this will bi used also as 802.1q vid
    #    option switch_dev 'switch0'
 #
    If your ethernet device is connected to a switch chip you must specify
it
    #    option switch_cpu_port '0'
  #
    Refer to switch port map of your device on openwrt wiki to know CPU port
    index
    #    list switch_ports '4'

####################
lime-defaults

    # Beware this file is NOT supposed to be edited by the end user, modify
    /etc/config/lime instead
    # If the same configuration is contained in both /etc/config/lime and
    lime-defaults file, the former will prevail
    # Beware this file is not supposed to store specific configuration, like
    "config net eth0"

    config lime system
        option hostname 'LiMeNode-%M4%M5%M6'

    config lime network
        option primary_interface eth0
        option main_ipv4_address '192.0.2.0/24'
        option main_ipv6_address '2001:db8::%M5:%M6/64'
        list protocols adhoc
        list protocols lan
        list protocols anygw
        list protocols batadv:%N1
        list protocols bmx6:13
        list resolvers 8.8.8.8
        list resolvers 2001:4860:4860::8844

    config lime wifi
        option channel_2ghz '11'
        option channel_5ghz '48'
        list modes 'ap'
        list modes 'adhoc'
        option ap_ssid 'libre-mesh.org'
        option adhoc_ssid '%H'
        option adhoc_bssid 'ca:fe:00:c0:ff:ee'
        option adhoc_mcast_rate_2ghz '24000'
        option adhoc_mcast_rate_5ghz '6000'
        option mesh_mesh_fwding '0'
        option mesh_mesh_id 'LiMe'

    #############

    somthing worth to note :
       %H and is not expanded in /config/wireless
        /etc/config/network  br-lan ip NOT set

    ##
    hope somebody can help
    #
    sorry have to stay with CC-RC3 but didnt have any problems with luci/lua
    until now
    running build for AR71xx

    greetings
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.libremesh.org/pipermail/lime-dev/attachments/20150815/2db5796d/attachment.html>


More information about the lime-dev mailing list